Assembly In Connection With Lunotherm And Lunotherm Fs - Lunos ALD Einbauanleitung

Remove the plaster protection
caps. Insert the external closure.
Mount the covering frame of the
inner screen. In doing so, note that
the lettering "LUNOS" is readable
at the bottom right. Insert the filter.
Snap the design screen of the
inner screen into place in open
position.

Assembly in connection with LUNOtherm and LUNOtherm FS

Note: For the assembly of the wall-tube 9/R 160 and the facade element LUNOtherm or LUNOtherm
The sound absorber endpiece is included in the delivery of LUNOtherm or
Insert the sound absorber endpiece as
pictured und push it to the front edge
of the pipe. With the facade element
assembled, the pipe has a stop up to
which the sound absorber endpiece
can be pushed. If necessary, reduce
the sound-absorber of the ALD in such
a way that the outlined distance of 127
mm to the pipe edge remains the sa-
me. This distance is covered by the
styrofoam coating of the wind pressure
relief. (This distance does not apply to
the version ALD-S).
Continue the assembly as described in the chapters on assembly
18
④
Design
screen
FS please refer to the corresponding installation manuals.
LUNOtherm FS.
of the ALD and ALD-S.
Covering
frame
Filter
Sound absorber
endpiece
down outside
EN
Outer grille
EN
127 mm