Shipping Units; Assembly: Ald - Lunos ALD Einbauanleitung

Shipping units

ALD
ALD Built-in device
9/WDS
+ Filter
+ Airflow regulator
ALD-S
ALD-S Built-in device
Sound insulation ring
+ Filter

Assembly: ALD

Prepare the wall opening for the wall-tube
(e.g. via core drilling, core bit Ø162 mm).
If necessary, shorten the wall-tube to the
installation length required. In doing so, en-
sure the necessary excess length of the tube
on both sides to bridge the plaster thickness.
If necessary, reduce the sound-absorber in
such a way that the outlined distances to the
pipe edge remain the same.
If necessary, shorten the outer star-shaped
sound-absorber e.g. using a cutter knife.
Insert the wall-tube and seal it all around
(assembly adhesive Order No. 038 733).
Apply the internal and external plaster. In the
case of an external closure to be plastered,
first replace the plaster protection cap outside
with the external closure.
Please check the delivery for completeness and mint condition!
Sound-absorber (3 pieces
- please order two additional sound-
absorber when using the full pipe
length 500mm)
Sound-absorber (4 pieces
- please order two additional sound-
absorber when using the full pipe
length 500mm)
①
3 mm
slope (if
required,
support
using wed-
ges - Order-
No. 039 938)
②
For both version is for com-
pletion required

Wall-tube

Inner screen

Outer cover
127 mm
inside
inside
min. 20 mm*
* only when mounting with
outer grilles Ø180 mm
EN
outside
outside
15