Setup; Fog Machine Ac Power; External Ac Power Supplies - Chauvet DJ PACK GOLD Bedienungsanleitung

3. S
ETUP
Fog Machine
AC Power
Fog Machine
Fuse
Replacement
External AC
Power
Supplies
JAM Pack™ Gold User Manual Rev. 2
The JAM Pack™ Gold fog machine has a fixed voltage power supply and it can work with an
input voltage of 120 VAC at 60 Hz.
The listed current rating indicates the product's average current draw under normal conditions.
·
Always connect the product to a protected circuit (circuit breaker or fuse). Make sure
the product has an appropriate electrical ground to avoid the risk of electrocution or
fire.
·
To eliminate wear and improve its lifespan, during periods of non-use completely
disconnect from power via breaker or by unplugging it.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even if the
rheostat or dimmer channel serves only as a 0 to 100% switch.
1. Disconnect the fogger from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and replace with a fuse of the exact
same type and rating.
5. Re-insert the fuse holder and reconnect power.
The product does not ship with a spare fuse; however, the safety cap has room for a
spare.
Always replace a blown fuse with a fuse of the same type and rating.
The JAM Pack™ Gold products (excluding the fog machine) have an external auto-ranging
power supply and can work with an input voltage range of 100 to 240 VAC, 50/60 Hz.
Page 17 of 114