Instructions For Use; Turning The Hob On And Off - Lakeland 70073 Gebrauchsanweisung

INSTRUCTIONS FOR USE

Unpack the hob and remove all the packaging materials.
Before first use, wipe the hob surface with a clean damp cloth and dry.
The hob should only be used at least 10cm away from a wall, to allow airflow through the
fan vents.

TURNING THE HOB ON AND OFF

Plug in and switch on the hob at the socket. The hob will bleep and the display will
illuminate and show '88' and then '—' to show it is on standby.
Press in and hold dial for 3 seconds, there will be a bleep.
The hob will illuminate for a few seconds and the display will
read '1' to show the hob surface is heating and on.
To switch off, press in and hold the dial for 3 seconds, there
will be a bleep. The hob light will go out and the display will
read '00' to show the hob is back on standby.
The fan will continue to run automatically to cool the hob,
until it has cooled below 60°C.
Switch off and unplug the hob at the socket.
WARNING
The hob surfaces can be very hot when the appliance is in use.
DO NOT TOUCH hot surfaces as possible injury could occur.
Allow the hob to cool completely before handling or moving
this appliance.
SELECTING THE POWER/TEMPERATURE
There are 6 power/temperature settings, and the hob
illuminates with a brighter light as the power/temperature
increases.
With the hob switched on, turn the dial clockwise to increase
the power/temperature, and anti-clockwise to decrease
the power/temperature.
The hob will bleep as it moves between each setting. It will
bleep twice at the minimum and maximum setting
('1' and '6'), as it cannot go beyond these.
Press in and hold dial for 3
seconds, there will be a 'BLEEP'
Turn the dial clockwise to
increase the power/temperature
7