Charging The Head- Phones - Kreafunk bGEM Bedienungshandbuch

CHARGING THE HEAD-
PHONES
Before using bGEM for the first
time please fully charge both ear-
buds using the below instructions.
1. Remove the USB protection cap
from each earbud.
2. Plug in the double micro USB
charging connectors to the
earbuds
8
3. Then connect the charging
cable to an AC adaptor or USB
port on a computer.
The red LED light is on:
Headphones are charging.
The red LED light is off: Charging
is finished.
It will take approximately 1.5
hours to finish the charging of the
headphones.
When the headphones are low on
power they will remind you every
two minutes by emitting "please
charge" and the red LED light will
start flashing instead of the blue
LED light. Please recharge the
headphones.
English