Sweeping Mode; Helpful Tips - Swim & Fun CleanRunner Handbuch

6.6 Filter tray replacement

6.7 Sweeping mode

Under normal circumstances, put nozzle towards obliquely upward so as to avoid blowing away
sewage on the pool floor.
For some specific pools, sweeping mode could be used for blowing up debris or fine particles lo-
cated in dead spots (corners) so as to be collected by the main filter system of the pool.

6.8 Helpful tips

• Unplug power connection immediately after use (Do not do it with wet hand or naked foot).
• The cleaner should not touch pool walls while lifting out to avoid scratching the pool surface or any
damage to the cleaner.
• Before lifting out from pool and placing on the pool edge, suspend the cleaner above water surface
for 10-15 seconds to release the water left inside the cleaner body.
• Please hold the cleaner handle to lift it out from pool and never pull the cable.
Page 40
MV-1046-CleanRunner-GB.indd 40
MV-1046-9-2016 . Swim & Fun Scandinavia . info@swim-fun.dk . www.swim-fun.com
Press buckle to disassemble.
Replace and press to assemble
© All rights reserved Swim & Fun Scandinavia ApS 2016
29/09/2016 12.22