Inhaltsverzeichnis; Important Precations - Swim & Fun CleanRunner Handbuch

GB Contents
1. Important precations ............................ 30
2. Introduction .......................................... 32
3. Safety ................................................... 32
4. Specifications ....................................... 33
5. Cleaner Structure ................................. 33
6. Operation Instructions .......................... 34
7. Trouble Shooting .................................. 41
8. Packing List .......................................... 41
9. Winter storage ...................................... 41
10. Warranty ............................................... 42
1.

Important precations

1. This model applies to swimmingpools with flat floors.
2. This model only applies to small pools corresponding to the cleaner's cable length. The clean-
er will not work in a too big pool because the limited cable will pull the cleaner upside down.
3. Do not try to move the floaters along the electric cable. Leave them always in the original positions.
4. Do not power on the unit when it is outside of the water.
5. Make sure the power cord is connected to a leakage protective device and appropriate
earthed socket.
6. Do not operate the cleaner when there are people in the pool.
7. Before powering on, make sure the cable is fully released to avoid any winding, which could
affect the cleaner's performance or cause damage.
8. The filter tray should be cleaned after use. This will prevent the dirty filter tray affecting the
normal operation of the cleaner.
9. The cleaner should be stored in a cool and ventilated place, away from direct sunlight.
10. The power supply unit should be placed in a shaded area. In order to avoid overheating and
the potential damage of components, never cover the power supply unit.
11. Only authorized personnel should open the cleaner's motor assembly and power supply unit.
Unauthorized service will invalidate the warranty.
12. In order to avoid any accident/damage, the power supply unit should be steadily placed at a
minimum distance of 3.5m from the pool edge.
13. Do not use the cleaner beyond the working environment/conditions stated in this manual.
Read this manual carefully before use.
14. Close the filtering system of your pool when the cleaner is in use.
15. Slightly water pollution may occur in case grease/oil sealed in the motor leaks.
16. Make sure the power unit is properly positioned for the cleaner to cover the intire pool surface
and that the cleaner has surplus cable once touching the pool end.
Page 30
MV-1046-CleanRunner-GB.indd 30
MV-1046-9-2016 . Swim & Fun Scandinavia . info@swim-fun.dk . www.swim-fun.com
© All rights reserved Swim & Fun Scandinavia ApS 2016
29/09/2016 12.22