Nordmende CTG50LPGBK Handbuch Seite 12

3. Part : INSTALLATION AND PREPARATIONS FOR USE
As gas is turned on, all connection parts and hose must be checked with soapy
water or leakage fluids. Do not use naked flame to check gas leakage. All metal
components used during gas connection must be clear of rust. Also check the
expiry dates of components used.
The points that must be checked during Fixed gas connection assembly
To assemble a fixed gas connection (gas connection made by threads, e.g. a nut),
there are different methods used in different areas. The most common parts are
already supplied with your appliance. Any other part can be supplied as spare part.
During connections always keep the nut on the gas manifold fixed, while rotating
the counter-part. Use spanners of appropriate size for safe connection. For all
surfaces between different components, always use the seals provided in the spare
set. The seals used during connection should also be approved to be used in gas
connections. Do not use plumbing seals for gas connections.
Remember that this appliance is prepare to be connected to gas supply in the
country for which it has been produced. The main country of destination is
marked on the rear cover of the appliance. If you need to use it in another
country, any of the connections in the figure below can be required. In such a
case, learn the appropriate connection parts and obtain those parts to perform
a safe connection.
Gas Pipe
Seal
Hose
Fitting
Gas Hose
with Collar
It is required to call the authorized service to be able to make the gas
connections appropriately and in compliance with safety standards..
ATTENTION! Surely do not use any match and lighter for control of gas
leakage .
Gas Pipe
Seal
Adapter
Mechanical
Gas Hose
Gas Pipe
Seal
Mechanical
Gas Hose
9
Gas Pipe
Mechanical
Gas Hose
Figure 6