Specifications - Motorola EN1005 Bedienungsanleitung

No ÒCHARGEÓ LED Indication
1. Check that the radio with battery is inserted correctly.
(see OPERATING INSTRUCTIONS on preceding pages).
2. Remove the radio from the Vehicle Adapter and use a pencil eraser to clean
the four metal contacts on the bottom of the battery. Place the radio with
battery Þtted back into the Vehicle Adapter. If the LED indicator still does not
light, replace the battery.
SERVICE
Other than cleaning all metal contacts and pins and dusting the unit with a clean,
dry cloth, any maintenance, troubleshooting, service, or repair of the Vehicle
Adapter should be performed only by authorized Motorola service personnel. A
service manual is available to qualiÞed Motorola service technicians.

SPECIFICATIONS

Part Numbers:
Input voltage:
In-line Fuse:
Temperature
range:
Dimensions:
(approximate)
Weight:
(approximate)
Speaker:
EN1005 Vehicle Adapter MB
EN1006 Vehicle Adapter VHF
EN1007 Vehicle Adapter UHF
EN1008 Vehicle Adapter UHF(2)
EN1009 Vehicle Adapter 300MHz
All units are supplied with RF Switch Adapter
and palm microphone
10.8Vdc to 31.2Vdc negative earth
(typical 12V or 24V car battery range)
20 x 5mm in-line fuseholder
4A quick-blow fuse
-30¡C to +60¡C (operational)
-25¡C to +55¡C (to speciÞcation)
-40¡C to +80¡C (storage)
H 25cm; W 10cm; D 8.5cm (without portable radio)
(H anti-kink device but without the 60cm cable tail)
(D includes mounting facility).
800g (without portable radio).
5 Watts maximum at 4 Ohms.
10
(66-88 MHz)
(136-174 MHz)
(403-470 MHz)
(450-527 MHz)
(300-350 MHz)