On/Off Switch; Rechargeable Battery - Posturite Penguin Gebrauchsanleitung

WIRED VERSION
1. Plug the USB cable into any spare USB port.
WIRELESS VERSION
2.4 GHz USB Micro Receiver
The micro receiver is located inside the housing on the underneath of the Penguin (J).
1. Remove the micro receiver and insert into a spare USB port of your computer or
laptop. Wait for a short time for your PC to recognise the penguin mouse.
2. Make sure the ON/OFF switch (F) on the base is in the 'ON' position.

On/off switch

For normal working conditions, make sure the ON/OFF switch (F) is turned to the
'ON' position. The ON/OFF switch is located on the base of the Penguin.
Note: It is advised to switch to the 'OFF' position if the Penguin is to be transported
as this will conserve power.
Auto power save
After approximately 20 seconds inactive - Penguin enters power save mode
After approximately 5 minutes - Penguin enters deep sleep mode
Inactive - click any button to reawaken

Rechargeable battery

The Wireless Penguin has an internal rechargeable battery. There may be a certain
amount of charge already in the battery.
To fully charge the battery, insert the USB end of the cable (G) into a spare USB port
of your computer and the DC end of the cable into the front of your mouse (I) see
diagram. Refer to the Charging Light Sequence section to indicate the battery level.
Rechargeable battery low power level indicator
Ice Blue light flashing Low battery (approximately 20% charge remaining)
Charging light sequence
When the charging cable is connected, a series of coloured lights in the illuminated
'P' logo will indicate different battery levels.
Penguin_User-Guide_0517_all-translations.indd 3 06/07/2017 15:30:21