Tack life PJS03A Betriebsanleitung Seite 6

This power tool is supplied from single-phase alternating current mains only. It is double insulated according
to EN 60745-1, IEC 60745 and can be connected to grounded or not grounded sockets. This power tool is
radio suppressed in compliance with EMC Directive 2004/108/EC.
This power tool is designed for sawing wooden, plastic and metal plates and shapes.
Operating instructions / Drawings
Power-on indicator
Connect the plug with power, then the power-on indicator will be light. To show the machine is power on.
Starting up (Fig.1)
Locking button
Fig.1
On/Off switch
Fig.
Speed adjustment
The speed can be set with the knob up on the tool. There are six different speeds. Position 1 sets the lowest
speed, and position 6 the highest. Hold the handle and turn the speed control to the required position with
your thumb.
Setting the Pendulum
For soft materials (wood, plastic etc.) set the oscillation to position 2 or 3.
For sharp-edged cuts, set the oscillation to position 0 or 1.
For medium-hard materials (hard wood, aluminum etc.) set the oscillation to a suitable position for the
application.
For thin workpiece, set the oscillation to position 0 or 1.
For hard materials (steel etc.) set the oscillation to position 0.
For round cuts, set the oscillation to position 0.
Mounting the saw blade (Fig.2)
Fig.2
Attention: The saw blade will become very hot during cutting due to friction. Pay attention for that when
removing the saw blade.
Protect yourself with protective gloves if necessary.
Adjusting the base (Fig.3)
For mitering and sawing near edges.
For miter and bevel cuts you can swivel the base by up to 450 in either direction after undoing the two screws
on the bottom. The angles 15°, 30° and 45° are marked but you can adjust the saw to any angle between
these markings as required.
Instant response operation
Switching on: Press the On/Off switch
Switching off: Release the On / Off switch
Continuous operation
Switching on: Press the On / Off switch and depress the locking button.
Switching off: Press the On / Off switch and release
Disconnect the tool from the mains. A special handle ensures quick
mounting.
Mount the saw blade
1. Push the handle and keep the holder in open position.
2. Insert the saw blade up to the end into the saw blade holder and
release the handle. Make sure the saw blade is touching the guide
Handle
roller.
3. Slightly pull the saw blade to ensure firm fit.
Remove the saw blade
Push the handle and keep the holder in open position, then pull out
the saw blade.
04