Dial Gauges With ∅ 3/8 Inch Attachment Stem; Verifying A Dial Gauge; Accessory For Lever Indicators - sylvac M3 Bedienungsanleitung

Because of the great gear reduction, a large force can be developed if the
mechanism gets blocked.
A security by friction protects the instrument of any damage but the gauge block
could be damaged (dial gauge at the end of the range). In this case, better verify the
gauge block !
5. DIAL GAUGES WITH ∅ ∅ ∅ ∅ 3/8 INCH ATTACHMENT STEM
Lightly undo the tightening nut and replace the ∅ 8mm socket with the ∅ 3/8 socket
that is supplied as a standard accessory.

6. VERIFYING A DIAL GAUGE

Unlock the handle by holding the mobile support with your left hand, and moving it
slowly until it touches the reference block.
Lock the lever at the stop and make sure, using the coarse adjustment dial, that the
total movement of the comparator can be made and check also that the reference
rod doesn't exceed its own limits. If needed, correct the position of the mobile
support.
Please consult the program SYCOPRO for WINDOWS FROM SYLVAC, this
program allows, during its configuration, the choice between the following verification
standards: DIN 878/ DIN 879/ DIN 2270/ NFE-11-050/ ISO/DIS 463/ UNI 4180-70
and others.
VERIFICATION RULES : Approach and fix the position of the comparator's needle
by turning the dial continuously in the same direction. It is possible to approach the
value by using the coarse adjustment dial and then to lock it before finishing the
adjustment with the fine adjustment dial. On the other hand, it is also possible to spin
the fine adjustment dial, in order to get an approximate value, and to then do the final
adjustments.
If a value has been accidentally overstepped, then move back quickly and redo the
approach in the normal measuring direction.

7. ACCESSORY FOR LEVER INDICATORS

19