Using Dante Controller; Dante Controller Overview; Audio Routing Settings - Tascam IF-DA64 Bedienungsanleitung

Using Dante Controller

Dante Controller overview

This card uses the Dante Controller application, which is available
at the Audinate website, to connect with other devices that
support Dante.
Download the latest version of the Dante Controller application
and an operation manual from the Audinate website.
Audinate download page
https://www.audinate.com/products/software/dante-controller
Make at least the following settings using a computer that has
Dante Controller installed.
•
Set the audio routing.
•
Adjust the sampling frequency and bit depth of each Dante
device.
NOTE
Settings made using Dante Controller are stored in the
built-in memory of each Dante device.
Unless settings are modified, connections will not change
even if Dante Controller is quit or the computer is discon-
nected from the Dante network.

Audio routing settings

When Dante Controller is launched, the Network View screen
shown below will open.
On this screen, you can set and monitor conditions related to the
Dante network.
Receiving device name
1
This is the name of a receiving device on the Dante network.
11
TASCAM IF-DA64