Specifications - IMG STAGELINE RGBL-430DMX Bedienungsanleitung

Total brightness
10
SETUPDIM
100% DIM
The total brightness can be adjusted from 0 – 100 %.
Note: The setting of this menu item will affect all operating
PROGRAM SOUND
modes ( ,
however, will only apply to this unit; it will not apply to any
slave units connected.
Behaviour of the unit after loss of the
11
control signal
DMX SIGN
FREEZE
When the light effect unit is operated via a DMX
controller or when it is operated as a slave unit in
the master/slave mode, it is possible to adjust the
behaviour of the unit after loss of the control signal:
FREEZE
"Freezing" of the LEDs with the most
recent control command
BLACKOUT
LEDs off
Setting for the display
12
SETUPDIS
DISP ON
ON
The display backlight is always on.
OFF
When no button is pressed any more, the dis-
play backlight will be switched off after
approx. 7 seconds. To switch it on again,
press any button.
Note: The display backlight will not be switched off
when the menu item
when no control signal is available at the DMX input.
Key lock
13
KEY LOCK
OFF
OFF
In the setting , the key lock will be deactivated.
10s 30s
When or
pressed any more, the buttons will be locked after
a few seconds (approx. 2 seconds for
approx. 5 seconds for
function, the message
appear when a button is pressed. To unlock, press
the buttons UP and DOWN at the same time until
KEY OPEN
is indicated. Then use the four buttons to
operate the unit as desired. When no button is
pressed any more, the lock will be activated again
after a few seconds.
and DMX mode). The setting,
DMXSETUP is selected and
is selected and no button is
10s
30s
). To indicate the lock
HOLD FOR PRESS+/-
Output of the control signal for the slave units
14
MASTER
ON
In the master/slave mode, set the master unit to
otherwise, the unit will not send any control signal
to the slave units.
Indication of firmware version
15
VERSION
3-21-25M
This menu item is used to indicate the firmware ver-
sion (operating system of the unit).
Indication of temperature inside the unit
16
LED PCB
TEMP XXX
This menu item is used to indicate the temperate
inside the unit, e. g.
Reset to factory settings
17
RESET
ENTER
To reset the unit to its factory settings, press the
button ENTER. (The factory settings are shown in
this chapter and in figure 2.) After that, the unit will
go to the mode

8 Specifications

Control protocol: . . . . . . . DMX 512
Number of
DMX channels: . . . . . . . . 1, 3, 7, 11, 12 or 25
Light source: . . . . . . . . . . four 30 W COB LEDs
Beam angle: . . . . . . . . . . 95°
DMX connections: . . . . . XLR, 3 poles
or
Pin configuration: . . . . pin 1 = ground
will
Ambient temperature: . . . 0 – 40 °C
Power supply: . . . . . . . . . 230 V~ / 50 Hz
Power consumption: . . . . 130 VA max.
Dimensions, weight: . . . . 52 × 12 × 16 cm, 5.3 kg
TEMP 043
at 43 °C.
PROGRAM
.
(RGBWA)
pin 2 = DMX-
pin 3 = DMX+
GB
ON
;
17