Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Pairing with additional sensors
IMPORTANT:
In the procedure below, you will need to activate sensors to pair them with
the Alarm unit. A door sensor can be activated by keeping the sensor and magnet against
each other and then move them away from each other. A PIR sensor can be activated by
waving your hand in front of it.
IMPORTANT: Do not pair sensors when all 4 LEDs are lit. When you want to pair a sensor
and you have entered pairing mode by long pressing the SET button and all 4 LEDs are lit,
you should short press the SET button again to select one of the 4 zones. For instance, if
you want to pair a sensor to zone 3, short press the SET button another three times after
you entered pairing mode.
The image below shows an example for zone 2.
Entering pairing mode
Make sure the Alarm unit is On. If this is not the case, long press the On/Off Button
[ ].
Long press the SET button [
lights on the front will light up.
Setup Zone 1
Now short press the SET button [
is now lit.
Activate the respective unit (door sensor or PIR) which corresponds to Zone 1. Two
beeps will be heard. The sensor for Zone 1 is now properly connected. Other sensors
can be connected for this zone by activating it at this stage.
This A1 Alarm is ready
for pairing sensors in
zone 2
] on the Alarm unit to enter pairing mode. The four
] once to select Zone 1. The first upper light
7
Werbung
