Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Preparation
9. Remove and replace component (10), at the corresponding position on the left, with the
special tool provided.
10. Fix component (7) in the corresponding opposite position.
Ventilation
Figure B
*Level the kitchen cabinet unit with a spirit level and a try square. Level the unit by placing
packing material underneath if required.
*A minimum gap of 38mm must be maintained at
the back of the appliance for ventilation.
*Air inlet A must be at least 200 cm square and
air must flow through the panel in the cabinet
plinth.
*Check that the position of the power socket (1)
is correct. AC voltage in the location at which
the appliance is to be used must comply with
that as shown on the data plate located on the
left inside wall of the appliance next to the
vegetable bins. The power supply must be
suitably earthed.
Werbung
Inhaltsverzeichnis
