Specification - KONIG ONSTAGE OSP-SX110ta Anleitung

CONNECTIONS
The system has a female XLR input that accepts a balanced line-level signal.
When connecting a balanced signal, be sure it is wired to AES (Audio Engineering Society) standards:
If connecting an unbalanced signal to the system balanced input, be sure that the signal high (hot) connection
is wired to pin 2 and the unbalanced ground connection is wired to the low and the ground connections of the
balanced input. If there is a ground-loop problem, try connecting the unbalanced ground connection only to
the input low connection (pin 3), and leaving the input ground connection disconnected.
The through output connectors allow you to connect more than one bass or other active speaker to your
system.
Simply plug the full range input jacks into the first speaker, and patch that speaker through jacks to the next
speaker as input jacks, and so on, daisy-chaining multiple speakers. The through jack is wired straight from
the full range input connector (there is no electronic circuitry between), so the signal coming out of the through
jack is exactly the same as the signal going in.
PLACEMENT
The bass system is designed to sit on the floor.
Never attempt to suspend the system by its handles. As with all electrical components, protect the system
from exposure to moisture.
If you are setting the system up outdoors, make sure they are covered if you expect rain.
AC POWER
Be sure the system is plugged into an outlet that is able to supply the correct voltage specifically for your
model. Also be sure that the electrical service can supply enough amperage for all the components connected
to it. We recommend that a strong supply of AC power is used because the amplifiers place high current
demands on the AC line.
Poor bass performance is often caused by a week AC supply to the amplifiers. Never remove the ground pin
on the power cord of the bass or any other component.

SPECIFICATION

Cabinet
Configuration
Nom. Impedance
Rated Power RMS
SPL 1 w/1 m
Frequency Response
Coverage Angle
Crossover Frequency
Voice Coil Protection
Components High
Components Mid (Low)
Material
Finish
Dimensions (w x h x d cm)
Net Weight (kg)
OSP-SX110ta
TOP / 10" FULL RANGE
Mid / High
Full range
Compact 2-way
4 Ohm
200 Watt
100 dB
(-10 dB) 55-20 KHz
90° × 40°
3000 Hz
PTC
1" Driver
1x10/200
10"
Plywood 18mm
Black lacquer
36x56x38
19
4
OSP-SX112ta
TOP / 12" FULL RANGE
Mid / High
Full range
Compact 2-way
4 Ohm
300 Watt
101 dB
45-20 KHz
90° × 40°
2000 Hz
PTC
1" Driver
1x12/300
12"
Plywood 18mm
Black lacquer
42x62x43
25