KONIG ONSTAGE OSP-SX110ta Anleitung Seite 3

Rear Panel Description – Sub Speaker
01. Full range input
02. Subwoofer level
control
03. Frequency control
04. Limit peak indicator
05. Through
(full range output)
06. Power switch
07. Power in
08. Fuse holder
09. Power out
TIPS
Do not expose electronic circuitry to moisture!
When the system is placed outdoors, be sure to protect it from rain. Keep drinks and all other liquids well
away from the cabinets to protect their electronic components from short circuits.
Ensure that the ducts on the enclosures rear panels are free of dirt and the system is properly ventilated,
otherwise electronic components may overheat and suffer damage.
Female XLR-type connector that accepts a balanced line-level signal from a
mixing console or other signal source
Adjusts the subwoofer level. Use this as a starting point for setting the balance
between the subwoofer and the main speaker.
With this control you can adjust the bass frequency from 40 Hz to 200 Hz to
balance the bass and top speakers.
The peak indicator prevents the amplifier outputs from overdriving the
transducers. It lights when the limiter is activated. It is okay for the peak indicator
to blink occasionally, but if it blinks frequently or lights continuously, turn down the
level control.
Male XLR-type connector that produces exactly the same signal that is connected
to the main input jack. Use it to daisy-chain several active systems of the same
signal source together.
Use this switch to turn the system on and off. Make sure the signal source level
control is turned down before you turn it on.
This is where you connect the AC line cord to provide AC power. Plug the line cord
into an AC socket properly configured for your particular model.
When a problem occurs in this system, the fuse will cut off the power. To replace,
use a standard fuse as specified.
AC power out to top system or another active system which is equipped with
powercon-3.
3