Bell UR900 Anleitung Seite 10

823.100
®
UR900
RF
AF
p
SCAN (automatic channel search)
As only one transmitter per channel is allowed, the UR900 receiver will
automatically search for interference free channels.
Prior to using SCAN, switch on all other wireless devices.
F
SET-SET-SET:
Fr
: starts SCAN starts
Once a free channel has been detected, it will be shown in the display.
Should SCAN suggest a channel which is already used or reserved,
SCAN should be continued to find an alternative channel.
RF (Radio Frequency)
07
Indicates the Level of the incoming RF Signal (RF=Radio Frequency)
AF (Audio Frequency)
Indicates the Level of the incoming AF Signal (AF=Audio Frequency)
MHz Frequency (UHF)
08
Indicates the working channel (CH) and frequency in MHz
BATT (battery status)
09
Reads the battery status of the connected microphone / bodypack.
(3 strokes: full, 2 strokes: good, 1 stroke: low)
flashing empty battery symbol: change batteries immediately.
Low batteries may lead to audible distortion or system failure.
Have extra spare Type AA batteries ready at any time.
IR (Sync)
10
m
n
o
V10 CH:02 MUTE
window of IR sync diode. (refer to (03) IR Sync)
®
l
IR
ANT
MHZ
BAT
r
q
SCAN is ready
(Channel display starts counting)
10
k
UHF
SET
IR
s
R
j
I
O
POWER