Electrical Connection - Teka HP-725.1 Einbauanleitung Und Pflegehinweise

ELECTRICAL CONNECTION

Check that the nominal voltage corresponds to that on the characteristics label.
Connection to the power mains must be made via an omni-polar switch that corresponds to
the installed power. The distance of separation of the contacts must be at least 3 mm and
allow disconnection of the appliance in case of emergency or for maintenance and cleaning.
Provide an earth connection to ensure the safety of the installer.
The oven must have a suitable earth connection in compliance with current applicable
regulations.
The appliance is supplied complete with a power cord. If it needs to be replaced, it will be
necessary to run the cable through the cable passage and make the connection as shown in
the provided diagram. The earth connection of the power cord must be longer that the other
wires to ensure that it disconnects in the event of traction with the cable passage open.
Tighten the screws of the cable passage, then close the cover.
ATTENTION: always make sure that the power supply is disconnected before cleaning the
oven in any way.
56