Troubleshooting; Transmitter Unit Are - ravioli JRAEA Series Bedienungsanleitung

RECEIVER UNITS JRAEA-JRAEB

Troubleshooting

On the receiver unit 8 LEDs are installed. Such LEDs can be very helpful in checking
and troubleshooting the operation of the radio remote control. LEDs meaning is specified
in the following table.
LED
READY
STOP
REMOTE LINK
LOCAL SEND
SETUP
FAULT
UNLOCK
KEYCODE ERROR This LED indicates a mismatch of the address code between the
4
Refer to the transmitter unit manual for further details – doc. ref. A,B,C,D
—————————
LED is on when START command is activated on the transmitter unit.
After the receiver is activated, any further pression of the START
button makes the LED blink.
LED lights on and blinks when the STOP button on the transmitter
unit is pressed. As the STOP button is then released the LED remains
in a steady on condition for about 1 second, and then it turns off.
LED is steady on when the unit is receiving correctly from the
transmitter unit.
Not used.
LED is on when on the transmitter unit the OPTION SETTING
feature has been activated.
This LED indicates an hardware fault on the receiver unit.
This LED indicates a fault on the radio module of the receiver unit.
transmitter and the receiver unit.
————————————————
CONDITION
25
ENG
4