BERG Toys Freestyler 2WD Gebrauchsanweisung Seite 16

EN
3
2
1
30Nm / 22ft.lbs
Fig 5.2
IMPORTANT: Do not allow the chain to be too tight. Remove the lower half of the chain
case to see how taut it is. It should be possible to push the chain down easily by 2cm in
the centre.
5.4.2 Brake
If the brake handle due to wear needs to be squeezed further in order to operate
properly, you need to adjust the brakes. The cable connector where the brake cables
are connected, is equipped with adjusting screws. By turning the adjusting screws
counter clockwise (see Fig 5.3), the free movement of the brake handle decreased and
the disc brakes will perform better. When the adjusting screws are entirely unscrewed
and the free movement of the brake handle is still too much, you need to replace the
brake blocks. Ask your BERG Toys dealer for more information. When the brake disc
runs out of true, you need to adjust the brake calaper. By turning the adjusting screw,
you can move the calliper sideward (see Fig 5.3).
Fig 5.3
Sheet nr. 49.90.50.50