Using The Radio - thomann Denon DN-300DH Benutzerhandbuch

Using the Radio

To use the radio:
1. If the unit is off, press the Power button to power it on.
2. Press the Band button to select AM or FM. The audio from the broadcast will start
automatically.
Important: Make sure you have properly connected the FM and AM antennae and set
the Region to the correct setting.
3. To select a radio station, use the Tuning Up/Down buttons on the unit or the remote
control. To jump to the previous or next station with clear reception, press and hold the
Tuning Up or Down button for more than 1 second.
To save a station to a preset number:
1. Select the desired station.
2. Press the Memory button on the unit or remote control.
3. Use the Number buttons (1–10/10+) on the unit or the remote control to enter the desired
preset number.
4. Press the Memory button to save the station to the preset.
To recall a saved radio station's preset number, use the Number buttons (1–10/10+) on the
unit or the remote control to enter the desired preset number. To recall presets higher than 10,
press the 10/10+ button on the unit followed by the additional number button to get to the
desired preset (e.g. to get to preset 12, select 10/10+ followed by 2).
Important:
The preset memory can hold up to 20 FM stations and 20 AM stations.
If you cannot receive a good broadcast signal, we recommend installing an outdoor antenna.
For details, inquire at the retail store where you purchased the unit.
When you receive a clear broadcast signal, affix the antenna in a position with tape where the
noise level is minimal.
10