Changing Light Bulbs - Küppersbusch EDL9750.1E Bedienungsanweisung Mit Montageanweisungen

Setting The Extraction Time
• Turn the hood on and select the required extraction
speed
• Select the programming time by pressing Timer.
• Each press of the button increases the programming
time by 10 minutes, up to a maximum of 80 minutes.
• To reset the programme, wait for over a second and
press the Timer button again.
• The speed and extraction time are displayed with the
LED indicator.
• The intensive speeds 6, 7 and 8 cannot be
programmed. These must be selected manually and have
a maximum duration of approximately 10 minutes.
Filter Saturation "F"
• Clean the filters when all lights of the LED indicator begin
to flash followed by an acoustic signal.
• Press "Filter Saturation" to reset this feature
Cleaning and maintenance
During cleaning and maintenance work, make
sure the safety instructions are complied with.
Cleaning the hood body
• If your kitchen hood is made of stainless steel,
use proprietary cleaners mentioned in the product
instructions.
• If your kitchen hood is painted, use lukewarm water and
a neutral soap.
Proceed with the following checks before calling the Technical Service:
Problem
The kitchen hood does not
work.
The kitchen hood does
not extract sufficiently or
vibrates.
The active charcoal filters have an active life of between three to six months, depending on
the individual conditions of use. These filters cannot be washed nor regenerated. They must be
replaced once their useful life comes to an end.
The manufacturer reserves the right to make changes and corrections to its products as it deems
necessary, without altering their basic characteristics.
Problem solving
Possible cause
The mains cable is not connected
to the network.
There is no current in the
network.
Filters are saturated with fat.
Obstruction in the air outlet.
Active charcoal filters
• Never use metallic scourers, nor abrasive or corrosive
products.
• Dry the kitchen hood using a cloth that does not
produce fibres.
• Do not use vapour cleaners.
To remove the filters from their fittings, press lightly on the
Cleaning the metal filters
locks and then pull them off.
The metal filters can be cleaned by soaking them in hot
water with neutral detergent until the fat dissolves and then
rinsing them under the tap or using special anti-grease
products. They can also be washed in a dishwasher. In this
case, it is advisable to stack them vertically to avoid food
residues to stick to them.
Cleaning in a dishwasher may damage the metallic surface
(blackening it), although this will not affect its fat retention
capacity.
Once clean, leave them to dry off and then fit them onto
the kitchen hood.

Changing light bulbs

For changing the light bulbs please contact the
manufacturer's nearest Technical Service.
Connect the mains cable to the
Provide current to the network.
Change or clean the active
charcoal and/or metal filters.
Remove the obstruction.
Solution
network.