Installation - Bimar Da15 Bedienungsanleitung

Fax +32 030 9904733

understand the hazards involved. Children shall not play with the appliance. Cleaning and user
maintenance shall not be made by children without supervision.
T
he supply cord cannot be replaced. If the cord is damaged the appliance the appliance should be
scrapped.
A
ttention: when using electrical appliances, always follow basic safety precautions to avoid the
risks of fire, electric shock and personal injury. You must take even more precautions when using
electrical appliances that incorporate a water reservoir: in the case of water overflows, immediately
remove the plug from the power outlet to adapter, verify that the electrical components of the
appliance are not wet, and if they are, dry thoroughly and carefully. Re-insert the plug into the
socket of the adapter, and then use the device. In case of doubt, contact a qualified technician.
D
o not remove the diffuser and the cover when the unit is running.
T
he appliance is only to be used with the power supply unit provided with the appliance mod.
GQ15-240050-AG.
I
f the unit is not running, remove the plug from the adapter's socket and empty the tank.
I
n order to avoid any risk of electrical shock, do not immerse the plug and the adapter's connector,
the electrical cable and the appliance in water or in any other liquid. .
D
o not move the appliance when it is on and when the tank is full.
D
o not place your hands, face or body directly above the steam output orifice when the appliance
is on.
D
o not inhale the vapor emitted from the orifice..
U
nplug the appliance when not in use.
D
o not expose the heater to the weather (sun, rain, etc.).
T
he supply cord cannot be replaced. If the cord is damaged the appliance should be scrapped.
D
o not pull on the power cord or the appliance to unplug the appliance from the electric socket.
I
f the electric cord is damaged, it has to be replaced by the supplier or an authorized service center
or a professionally qualified, to avoid any risks.

INSTALLATION

After removing the packing materials, check the integrity of the appliance; if you are unsure, do not
use it and ask for qualified professional help. The packing materials (plastic bags, polystyrene
foam, nails, etc.) must be kept out the reach of children because they are potential sources of
danger; but dispose of them in accordance with current law.
Before connecting the appliance, check that the voltage shown on the data plate matches that of
your electricity. In the event of incompatibility between the electric outlet and the plug of the
appliance, have the outlet replaced with another more suitable type by professionally qualified
personnel, who will make sure that the section of the wires of the outlet is appropriate for the
absorbed power of the appliance. In general, the use of adapters or extension cords is not
recommended; if their use is indispensable, they must conform to existing safety standards and
their current capacity (amperes) must not be less that the maximum of the appliance.
Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the
appliance could upset.
Make sure that the cable is correctly positioned, that it is not touching hot elements or sharp edges,
is not wound around the utensil, is not twisted up on itself or in the way to prevent the utensil from
being pulled over. Check that you cannot trip over to prevent accidental falls or harm to persons.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
9 32
/
Assembly page 9/32