Werbung
4>Join the Heating Element Assembly
(1) and the Upper Post Assembly (7)
together ,then fix them tightly by
rotating the Knob, and put the power
cord supply into the clamp.(fig.4)
5>. According to the request of use angle,
Heating Element Assembly can adjust
Angle at 0º~45º.(Fig.5)
5-OPERATION
The appliance is switched on by means of the pull switch (5). The slight
vibration noticeable when the appliance is switched on will stop after a
few seconds.
6-OUTPUT
-Position 0: Stop
-Position 1: 650W (normal power)
-Position 2: 1300W (intermediate power)
-Position 3: 2000W (full power)
7-MAINTENANCE
Your appliance dose not requires any particular maintenance. However, in
the event of a malfunction, please consult an Approved Service Center.
Power Cord
Clamp
Heating Element Assembly
Tube Cover
Upper Post Assembly
Middle Post
Lower Post Assembly
4
Heating Element Assembly
5
Knob
Power Cord
Base Assembly
Body
Werbung
