Electrical Safety - Toolland VL106 Bedienungsanleitung

If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
Class 2: this device is designed with double insulation.
Do not use near inflammable products or in explosive atmospheres. Heat can cause fire to
inflammable products even when they are not in sight. Only use in properly ventilated areas.
Device heats up during use. Never touch the nozzle or heat shield while using the device. Let the
device cool down for 30 minutes. Some parts of the device get really hot, even after a short use.

Electrical Safety

Never modify the plug or power cord in any way. Do not use adapters with
earthed devices.
Avoid any body contact with earthed or grounded surfaces such as pipes,
radiators, cookers and refrigerators. There is an increased risk of electric shock if
your body is earthed or grounded.
If use of the device in humid locations is unavoidable, connect the device to a
power supply protected by an RCD (Residual Current Differential) device.
Personal Safety
Stay alert, watch what you are doing and use common sense when operating the
device. Do not use the device when you are tired or under influence of drugs,
alcohol or medication.
Avoid unintentional starting. Make sure the switch is on the off position before
plugging the device into the mains and/or fitting the batteries, picking it up or
carrying it. Do not carry the device with your finger on the on-off switch. Do not
plug in the device with the switch in the on position.
Do not overreach. Keep proper position and balance at all times.
Dress in a suitable manner. Do not wear loose clothing or jewellery. Keep hair,
clothing and gloves away from moving parts.
Never aim the device directly at humans or animals.
Do not use the device as a heat source in your house or for melting ice and snow
or for any other use than intended.
The Device
Do not force the device. Use the correct device for your application.
Do not use the device if the switch does not make it possible to change from the
operating condition to stop and vice versa. Any device which cannot be controlled
by the switch is dangerous and should be repaired.
If the device is running erratically or something unusual occurs during use,
immediately switch off the device and unplug from the mains. Inspect the device
before using it again. Repair must only be carried out by a qualified technician.
Disconnect the power cord before any adjustment, changing an accessory or
before storing the device.
Keep an idle device out of the reach of children and do not allow persons
unfamiliar with the device or these instructions to operate it.
Maintain the device. Check that there is no misalignment or obstruction of the
moving or broken parts, or any other condition that could affect the operation of
the device. In the event of damage, have the device repaired before using it.
V. 02 – 31/01/2018
VL106
4 ©Velleman nv