Xiaomi Snoppa M1 Schnellstartanleitung Seite 6

B. Without Snoppa App
Power on
C AUT I O N
P IN CH I N G
HAN D
Twist 90˚ and
then pull out
(be careful of
pinching hand
when collapse
the handle).
Power off
Press & hold for 2 seconds until the indicator light goes o .
Remind：Collapse the tilt-axis to the grip, the gimbal will enter
standby mode, and all the motors will stop working. Within 20
seconds of standby mode, motors can be reactivated by rotating
the tilt-axis down until the intersection angle goes larger
than 60 degree. After 20 seconds in standby mode, the
gimbal will power o automatically. After 30 minutes
without any operation in o mode, the Bluetooth will be
deactivated and cannot be found in the device list.
To reactivate it, short press the button and the indicator
will blink green.
Notice: Please avoid starting the gimbal without a phone
mounted on the holder. This may cause issues for the
gimbal.
Rotate the tilt-axis
of the phone until
the intersection
angle goes more
than 60 degree.
Indicator light/
Function button
Press the indicator button,
when it ashes green,
press it again and hold it
until the gimbal starts up.
The indicator light will
show a constant green.
5