Using Your Ice Maker; Troubleshooting - Guzzanti GZ-122 Gebrauchsanleitung

USING YOUR ICE MAKER

1. Open the cover, remove the ice basket and pour water into tank.
Keep water level below the MAXIMUM water level mark.
2. Press "ON/OFF" button on the control panel to begin the ice making cycle.
3. Select the ice cube size by pressing the "SELECT" button. If the room temperature
is lower than 15°C, it is recommended to select small ice cube in order to avoid ice
sticking together.
4. The ice making cycle lasts approx. 6 to 13 minutes, depending on seletion of ice
cube size and the room temperature. The recommended room temperature is 10°C
to 43°C.
5. If water pump can't inject water, the ice maker will stop automatically, and the "Add
Water" indicator will be on.Press "ON/OFF" button, fill water up to the max. water
level mark and press "ON/OFF" button again to turn on the unit again.Allow the
refrigerant liquid inside the compressor at least 3 minutes to settle before restarting.
6. The unit stops when the ice basket is full and the "Ice Full" indicator will be on.
Warning:
Direct sunlight or sunlight reflection may cause infared sensor malfunction. If
the unit doesn't stop even ice cubes obstruct sensor, move the unit where no
sunlight.
7. Change water in the water reservoir every 24 hours to ensure a reasonable hygiene
level. If unit isn't to be used, drain all the water and dry the tank.

TROUBLESHOOTING

Ice making cycle is
normal but no ice
formed.
Ice cubes stick
together.
Water temperature in
inner tank is too low.
Room temperature or
water temperature in
inner tank is too high.
Refrigerant in cooling
system leaks.
Pipe in the cooling
system is blocked.
The ice making cycle is
too long.
Replace the water. Temperature of
water recommended at 8-32°C.
The room temperature should
be 10-43°C, water temperature
should be 8-32°C.
Verify by a qualified technician.
Verify by a qualified technician.
Stop the ice maker, and restart it
when the ice blocks melt. Select
the small size ice cube selection.
9