Axis F41 Installationshandbuch Seite 20

AXIS F41 Main Unit
7. If required, attach the RS232 cable to connect to auxiliary
equipment.
Shorten Sensor Unit Cable
The sensor unit is delivered with a cable. Note that this cable cannot be
extended. To shorten the cable follow these steps:
1. Cut the cable to the desired length. Measure from the sensor
unit.
2. Strip the plastic outer coating from the end of the cable.
3. Peel back the shield.
4. Flatten the colored wires in the order described below.
NO NO NO TICE TICE TICE
Make sure that the wires stay in the correct order and that the
cable shield makes good contact with the connector shield.
5. Insert the wires all the way into a shielded 6P6C RJ12
connector.
6. Use a crimping tool to fasten the connector to the cable.
1
Brown
2
White/brown
3
Not used
4
Not used
5
White/blue
6
Blue
20