Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Protection
Using Overcurrent Protection
To protect against overcurrent, set up the maximum current and then press the OCP button.
Press Off/On to apply the output to the load.
If the output current becomes higher than the set value, the power supply cuts off the output
and the OCP indicator flashes.
Disconnect the load. To recover, press the OCP key.
7.
Remote Control via PC
To operate the power supply via the included pc software, proceed as follows:
1.
Install the software on your pc and launch the software.
2.
Connect the power supply to the pc via the USB [17] port and switch it on.
Note: the keys on the front panel are locked when the power supply is connected to a pc. You can
only operate the power supply via the pc. The LED display and indicators work normally.
3.
Click the shortcut icon to launch the software. The opening screen appears.
4.
Choose the connected interface number from the drop list and click ENTER to confirm.
Werbung
Inhaltsverzeichnis
