How To Use The Appliance; Operating Modes - PARMAZ ARD-12 Gebrauchsanleitung

This appliance can be used for PEARL cooling, heating (only model PEARL TOP), dehumidification and ventilation.
When switching between modes, the fan continues to turn but the compressor stops: the compressor will re-start after 3
minutes. This delay protects the compressor from potential damage.
Cooling, Heating, Ventilation
THE DISCHARGE TUBE MUST BE CONNECTED to the appliance AT ALL TIMES: the only exception is when the
appliance is used in dehumidification mode only, in which case the appliance should be left to discharge directly
into the room for maximum efficiency (see the "Dehumidification Mode" paragraph).
Clean the air filters under the easily removable rear grille regularly to keep the air conditioner working efficiently.
1. COOLING MODE (COOL)
• The "Cool" LEO on the control panel will turn on.
• The temperature can be adjusted to between 16 ºC and 32 ºC.
• In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the temperature
setting and retains this setting when it is switched on again.
• In this mode, the fan speed can be adjusted and the Timer and SLEEP functions can be set.
• For more silent operation, run the fan at low speed.
2. HEATING MODE (HEAT) (Pearl top)
• The "Heat" LEO on the control panel will turn on.
• The temperature can be adjusted to between 16 ºC and 32 ºC.
• In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the temperature
setting and retains this setting when it is switched on again.
• In this mode, the fan speed can be adjusted and the Timer and SLEEP functions can be set.
• For more silent operation, run the fan at low speed.
3. DEHUMIDIFICATION MODE (DRY)
• Press the MOOE button to select the dehumidification mode.
• The temperature is controlled by the electronic board and cannot be adjusted.
• In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the settings and
retains them when it is switched on again.
• The fan speed is set to low and cannot be adjusted.

HOW TO USE THE APPLIANCE

\

OPERATING MODES

Dehumidification
34