Before Use - ELAC Debut A4.2 Bedienungsanleitung

Philosophy
Thank you for purchasing this ELAC product.
When we started in 1926, ELAC has always strived to achieve the very best. This holds true as much today as it
did back then.
Your new ELAC speakers are built to the highest standards using high-quality components that are carefully
constructed to deliver the best-in-class sound quality. They are developed by a passionate group of individuals
whose soul purpose is to bring a new dimension of sound quality into your home. Enjoy!

Before Use

Avoid damage to the speakers and other components:
• Unbox the speakers carefully to avoid physically damaging your speakers.
• Use appropriate gauge wires (minimum of 16 gauge wire for runs up to 25 feet).
• Make sure wire polarity is connected correctly. Most speaker cables are coded for ease of use. Make
sure positive (red) connection on the amplifier terminal is connected to the positive (red) on your
speakers. Follow the same instructions for the negative side. Strip off approximately 1/2"of the insulation
from the ends of the speaker cable, twist the bare strands and insert into the binding post.
• The A4.2 speakers are specifically designed for use as Atmos Enabled speakers. They cannot be used
as traditional speakers. Doing so will damage the speakers.
• Keep your equipment turned off before connecting speakers.
• Check to ensure positive and negative wires are not touching each other once they're connected to the
speaker terminals.
ELAC Debut A4.2 Speakers | www.elac.com | Page 4
Amplifier Terminals