Installation; Functional Diagram - Lacme CLOS 100 Bedienungsanleitung

Installation

(After installing the posts and wires !)
EARTH/GROUND
FENCE OUTPUT
FENCE RETURN
ON
POWER
MAINTENANCE : Losses will occur if the fence wire or tape comes into contact with the earth or overgrown vegetation. These losses gradually
reduce the intensity of the red light (optional) until it is eventually completely extinguished. Regularly check your installation and, if necessary,
remedy the situation. The ground surrounding the earth/ground rod should be kept damp.

FUNCTIONAL DIAGRAM :

Connect the CLOS "EARTH" terminal
CAUTION, this rod must be more than 10 metres from the domestic earth of the mains supply.
Connect the "FENCE OUTPUT" terminal
to the fence starting point.
(Optional) Connect a return path from the
fence to the "FENCE RETURN" terminal.
Once all the connections have been made, plug the curent socket to
the mains supply : the "ON" light (to the right) should flash approximately
40 times per minute and CLOS will emit a "tap" at the same rate.
If the installation of the fence and earth/ground rod is correct (and if the optional
connection to the "FENCE RETURN" has been made), the "POWER" light (to the left)
should flash at the same rate as the "ON" light.
to the earth/ground rod.
Use the highly insulated cable
(HV output wire) for this
purpose. If the cable is too
short, extend it using the FISOL.
Insulator
Earth connexion
230 V mains connexion
Fencing output
Fencing return
On indication light
Power control light
Earth/ground output
6
Insulator
Fence wire connected to
the "Total Power Output"
terminal