Elinchrom ZOOM Pro Gebrauchsanleitung Seite 7

• Always switch off the power pack before connecting or disconnecting
heads.
• The unit, the flash tube and accessories may become very hot during
and after use! To avoid injuries, handle with isolating cloth or wait until
parts have cooled down.
• Never flash into the eyes of a subject without warning. Close use may
affect eyesight.
• There is high voltage and there can be high currents, so please apply all
the usual safety precautions when handling the unit.
• Protect the flashhead and the power pack when used in humid
conditions, but ensure ventilation for cooling!
• Flash cables must be connected correctly before switching on the
power pack.
• Acclimatizing: If the unit has been exposed to very cold conditions,
sudden exposure to warm or humid air may cause condensation and
malfunction.
• Prevent direct sunlight, which might heat up the head and the power
pack.
• Do not open the unit. In the event of damage, apparent failure, or a
defect flash tube, please contact the Elinchrom Service Centre.
• Flash tubes and modelling lamps may generate high pressure during
operation. Explosions may occur with aged flash tubes and incorrect
fuse / halogen lamp combinations. For this reason the flash tube is
covered with a glass dome. In case of a damaged flash tube or a
broken security cover the flashhead must be immediately unplugged
from the power pack and sent to an authorized Elinchrom customer
service.
• Only lamp connectors with immaculate contacts must be used,
burned or/and corroded contacts may cause explosions in the area of
connectors and lamp sockets.
• Do not route cables across the studio floor if possible, so that damage
is prevented. If routing across the studio floor cannot be avoided, then
it must be ensured that vehicles, ladders, etc. do not damage cables.
Damaged cables and cases must be immediately replaced by customer
service.
User Manual
EN
7