Adax SET SLAVE SWITCH Bedienungsanleitung Seite 17

4
A red flashing lamp indicates
that the slave switch is in the
coupled mode.
(When the ON/OFF
switch is activated, a
constant red light indicates that
the Slave Switch's power out-
put is ON.)
3
Press in the connect button on
the unit(s) that are to be
included in the same zone.
(An unlimited number of slave
switch units may be coupled to
the same zone at the same time.
The connect button must then
be activated on all the units. The
slaves will switch on and off si-
multaneously.)
(There are three zones for slave
switches in addition to the Adax
SET master. These four zones
operate independently of each
other.)
GB 17