Proper Use - Nakayama ET2500 Originalbetriebsanleitung

Assembling the housing
Plug the housing parts together as shown in
Figure 2 and tighten the 4 screws (a, b, c, d).
Make sure when doing so that the cable is not
jammed.
Assembling the guard hood
(Figure 3)
Plug the guard hood (6) onto the motor head (5)
over the line spool (7) as shown and secure with
the supplied screw.
NOTE: When turning the guard hood, make sure
that it rests horizontally on the grass trimmer
housing.

Proper use

The trimmer is designed for cutting lawns and
small areas of grass in private and hobby gardens.
Tools for private and hobby gardens are not
suitable for use in public facilities, parks and
sport centers, along roadways, on farms or in the
forestry sector.
For the tool to be used properly it is imperative to
follow the instructions set out in the
manufacturer's directions for use.
Important! It is prohibited to use the tool to chop
material for composting because of the potential
danger to persons and property.
Starting up
The grass trimmer is designed only to cut grass.
A short or worn down nylon line leads to poor
cutting quality.
IMPORTANT! Prior to starting up the
equipment for the first time, remove the
guard from the blade for regulating the line
length (Figure A/8).
14
IMPORTANT! Make sure that you pull out the
power plug before adjusting the line length!
The nylon line must be pulled out with force
when starting up for the first time. To do this,
press the pushbutton (Figure 5) and pull the line
out to the edge of the guard hood. The line will
be cut to the correct length when the cutting
head starts up again. A short or worn down nylon
line leads to poor cutting quality.
To restore the correct length of line, press the
grass trimmer to the ground while the cutting
head is running. This enables the line length
to adjust itself (Figure 5).
To obtain maximum performance from your
grass trimmer, please follow the instructions
given below:
. Never use the grass trimmer without the guard.
. Do not mow grass when it is wet. The best
results are achieved with dry grass.
. Connect the power cable to the extension cable
and attach it in the handle (Figure 4).
. To switch on your grass trimmer, press the
ON/OFF switch (Figure 4/3).
. To switch off your grass trimmer, let go of the
ON/OFF switch (Figure 4/3).
. Do not allow the grass trimmer near the grass
until the switch is pressed, i.e. the grass trimmer
is in operation.
. If the grass is long, the grass must be cut shorter
in stages, starting from the tip (Figure 6).
. To cut properly, swing the machine sideways
while moving forwards. In doing so, keep the
grass trimmer inclined at an angle of
approximately 15° (Figure 7).
. To avoid unnecessary wear on the line, keep the
grass trimmer away from hard objects.