RCS AUDIO-SYSTEMS DVD-200X Bedienungsanleitung Seite 36

9.3.3 Center Speaker
Selection of Large or Small is same with that of front speaker. The speaker will have no signal output if set to None.
Notes: If the Subwoofer is On, Center is set to None or Small, and bass from the center channel is redirected to the
subwoofer. If the content contains a discrete subwoofer channel, it is also sent to the subwoofer. If the Subwoofer is Off,
Center is set to None or Small, and bass from the center channel is redirected to the left and right channels. If the content
contains a discrete subwoofer channel, it is discarded.
9.3.4 Surround Speaker
Selection of Large or Small is same with that of front speaker. The speaker will have no signal output if set to None.
Notes: If the Subwoofer is on, Surround is set to None or Small, and bass from the surround channels is redirected to the
subwoofer. If the content contains a discrete subwoofer channel, it is also sent to the subwoofer.
If the Subwoofer is Off, Surround is set to None or Small, and bass from the surround channels is redirected to the left
and right channels. If the content contains a discrete subwoofer channel, it is discarded.
9.3.5 Subwoofer
Selecting to enable/disable the subwoofer output when 6 Channel analog output is used. The following options are available:
None Subwoofer is off. Bass from center and surround channels is redirected to the left and right channels. If the content
contains a discrete subwoofer channel, it is discarded.
Present Subwoofer is on. Bass from center and surround channels is redirected to subwoofer. If the content contains a
discrete subwoofer channel, it is also sent to the subwoofer.
Note: Bass Management is not available for MP3 or WMA bitstream ; therefore, it will be disabled during the playback of
those streams.
9.3.6 Test Tone
Selecting the Test Tone setting allows the user to test the player's audio output on each speaker. When you select channel,
a short burst of pink noise will be sent to corresponding channel
9.3.7 Center Delay
Selecting the Center Delay setting allows the user to enable/disable the center output delay.
9.3.8 Surr. Delay
Selecting the Surr. Delay setting allows the user to enable/disable the center output delay.
9.3.9 Digital output
Selecting the Digital Output setting allows the user to adjust the audio output on S/PDIF ports to work in harmony with the
audio equipment (e.g. receiver, speakers) connected to the player.
Off Digital audio output is disabled.
PCM Select this option when you are going to use stereo signals (2 channels). You should combine this option with the
option "Lower sampling rate," which we explain further on
All If you select this option the player will use the DVD's original audio track. Use this option when you want to use the
Dolby Digital AC3 signals through the optical or coaxial audio output.
9.3.10 Night Mode
To adjust the linear compression ratio , select to ON when playing a disc in the day so as to get better acoustical effect; while
at night, you can select to OFF.
9.3.11 Prologic
Off: Pro Logic decoding is off. Two-channel sources are output only on the left and right channels.
On: Enable Pro Logic decoding
36
DVD-200 X