Getting Started - Clearaudio balance V2 Bedienungsanleitung

User manual / Bedienungsanleitung
4
Variable function
The „mode" button in the „variable" positon (not pressed) unlocks the gain setting, which means
that the volume can be adjusted using the front volume knob.
In the „fix" option („mode" button pressed), the volume knob is deactivated and the
plays at maximum volume.
In this case you can control the volume using other components in your hi-fi system.
Please note:
To protect your loudspeakers from any damage, please make sure that your power
amplifier(s) are always switched off when you are connecting the interconnects to or
balance V2
from the
Before adjusting any settings, be sure to switch off the power of the
the switch on the rear panel of the power supply.

2. Getting started

1. Switch off all of your hi-fi system components and connect your
2. Follow the set-up adjustment steps described above according to your components.
balance V2
3. Connect the
4. Connect the power supply to the mains supply and switch the unit on (Pic. 2).
5
balance V2
Pic. 2: Rear view of the
4
phono stage.
with the 15-pin Sub-D connector to the power supply unit (Pic. 2).
7
6
3
4
2
phono stage
6
3
4
1
© clearaudio electronic GmbH, 2018/10
balance V2
balance V2
using
balance V2
phono stage.
5