Specifications - Genie 755 AFX Bedienungsanleitung

13. Never open the casing. In the event of problems with the device, please contact our hotline.
14. The device may not be operated with a damaged power cord.
15. For indoor use only.
Paper Jams and overload protection:
GENIE 755 AFX is equipped with a motor overload protection device. The normal short duty
cycle for continuous shredding at maximum capacity is 5 minutes. When using the automatic
infeed, the continuous shredding time extends to 8 minutes due to lower power needed for
single sheets of paper. The power may terminate automatically in case of the following
abnormal situations:
1. Operating the shredder at the maximum capacity continuously for a prolonged period of
time, e.g. more than 5minutes for computer paper without stopping.
2. Exceeding the shredding capacity e.g. inserting more than five (5) sheets at one pass, or if
the paper is not fed squarely into the feed opening.
Both abnormal operations may result in the activation of the automatic motor overload
protection, which terminates the power to the unit .If this occurs, you should:
1. Unplug the power cord from the AC outlet to allow shredder to cool down. Tear or cut off
any excess paper from the top of the shredder.
2. Plug the power cord back into the AC outlet and place the Switch in REV. Pull the
remaining paper out of the cutters. Place the Switch back to the Auto position if necessary
clear the feed opening of any remaining shredded pieces of paper, Keep fingers away from
feed opening to avoid harm.
3. With the Main Switch in the AUTO position and the feed opening clear, you are now ready
to resume normal shredding.

Specifications:

Shred type:
Shred Size:
Shredding Capacity:
Feed Opening:
Input:
Shredding speed:
Basket capacity:
Security level (DIN 66399-2):
Cross cut
4x40 mm
5 Sheets for manual feeding,
75 Sheets for auto feeding (one at a time)
220mm
220-240 volt AC, 50HZ, 0.8A
1.6m/min (5 sheets) / 3.0m/min (1 sheet)
21 L
P-4
- 9 -