Dometic MC 402 Montageanleitung Seite 12

Safety information
• Protect the device from humidity and moisture to prevent sparks, fire
or electric shocks.
• Switch off the device immediately
– if water gets into the device,
– if smoke is coming out of the device or
– if the device emits an unusual smell.
• This reader is certified according to the laser protection class 1. The
accessible laser radiation is safe under reasonably foreseeable
conditions. Avoid looking directly into the laser beam. Never open
the housing of the device. Do not make any repairs to the device.
Contact the manufacturer (see addresses on the back of the operating
manual).
I
NOTICE!
• If you use the monitor in vehicles, the vehicle should be running during
operation to prevent the vehicle battery from discharging.
• Only insert round discs into the device.
Do not use any other shaped discs.
• Only clean the discs with a soft, dry cloth from the middle to the outer
edge. To remove dirt, use a mild cleaning agent.
• New discs may have flaking on the edges. Remove these by carefully
running the side of a ballpoint pen around the edge.
• If the interior of the vehicle becomes too hot e.g. as a result of direct
sunlight, wait until the temperature has cooled down to the operating
temperature (under 60 °C).
12
MC402
EN