Uvex pheos LED Lights Bedienungsanleitung Seite 12

3. Attaching the helmet lamp to the helmet
In order to attach the helmet lamp, place the
holder of the helmet lamp onto the helmets lamp
receiver and press down the lamp until it sits
tight. (Fig. 3)
Operating the headlamp
The headlamp needs to be loaded before use.
The provided loading adapter is used for this.
For this, observe point 2. After plugging in the
loading device, the status LED on the loading
device lights up red. The lamp is now loading. If
the status LED is green, the lamp is completely
loaded.
The red status LED in the helmet lamp only
signals the connection to the loading device!
The headlamp has 4 different illumination modes.
Press the yellow power switch to switch between
illumination modes. The helmet lamp switches
off once all illumination modes have been cycled
through.
12 | GB