Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
OPERATION
Connections
•
Before using this unit, make sure that the AC Adaptor (21) is correct
voltage.
•
The unit is supplied with AMP output jacks. The AMP (20) jacks are
unbalanced and used to connect to your amplifier.
•
The MIC L (15) and MIC R (16) input accepts a 1/4" connector.
•
On the rear panel are two stereo PHONO/LINE (17) 18 inputs, and 1
stereo LINE(19) inputs. The PHONO/LINE (4) enables you to set the (17)
input to phono or Line. The PHONO/LINE (6) enables you to set the (18)
input to phono or Line. The USB/LINE (8) enables you to set the input
to USB or Line (19). Headphones can be plugged into the rear panel
mounted HEADPHONE (14) jack.
Operation
•
POWER ON: Once you have made all the equipment connections to your
mixer, press the POWER (12). The power will turn on and the POWER
LED (22) will glow RED.
•
CHANNEL 1: SWITCH (4) allows you to select the PHONO 1/LINE 1 (17)
jack to input phono or line level. The CHANNEL SLIDE (5) controls the
input level of this channel.
•
CHANNEL 2: SWITCH (6) allows you to select the PHONO 1/LINE 1 (18)
jack to input phono or line level. The CHANNEL SLIDE (7) controls the
input level of this channel.
•
CHANNEL 3: SWITCH (8) allows you to select the USB OR LINE 2 (19)
jack to input phono or line level. The CHANNEL SLIDE (9) controls the
input level of this channel.
•
CROSSFADER: The CROSSFADER (10) allows you to the Mixing CH1/
CH2 source into another.
•
TALKOVER (3) The purpose of the talkover section is to allow the
program playing to be muted so that the mic can be heard above the
music. When you press the SWITCH, the talkover will be on and the
volume of all sources except the Mic inputs are lowered by 12 dB. The
Micro (2) allow you to control the level of MIC1/MIC2.
•
Connect your headphones to the headphones socket and select the
desired channel (channel 1-3 or MIC) for monitoring with the Cue switch
(1). With this knob PHONE (11), you can adjust the headphones volume
•
DISPLAY: The DISPLAY (13) indicates either the MASTER output left and
right levels.
•
The USB (23) jack can connect to USB stick.
•
|<< (24: Use this button to re-start the track or to select the previous
track.
•
Play/ Pause (25): Each time you press this button, the operation changes
from play to pause or from pause to play.
•
>>| (26): Use this button to select the next track.
EN
9
Werbung
Inhaltsverzeichnis
