Malfunctions; Aftercare - FireWare Smoky Multi Socket Gebrauchsanweisung

User Manual
Smoky Multi Socket

6. Malfunctions

Problems with the Smoky Multi Socket.
Problems
Appliance does not turn on
LED light is not burning
No smoke from the smoke unit
Smoke production does not stop
7. After care
It is recommended to remove the smoke liquid from the smoke unit after use. You can do this by
holding a cloth against the mouth and dripping the liquid on the cloth by slanting the junction box
or keeping it upside down. If you have the Smoky Multi Socket in a fixed location make sure that
www.FireSales.nl
EN
Possible cause
No plug in the socket
Not the right feed
On/off switch if turned off
No plug in the socket
Not the right feed
On/off switch if off
LED light is defect
No plug in the socket
Not the correct feed
On/off switch is turned off
Too much liquid in the smoke unit
No liquid in the smoke unit
Metal needle in the smoke unit is defect
On/off switch is turned on
Plug is still in socket
A lot of smoke liquid in the smoke unit
the plug gets removed from the socket. If the appliance
is not used for more than two days in a row it is
recommended to remove the remaining smoke liquid.
OFF
1.
2.
Solutions
Put the plug in an earthed socket
Use a 230 V feed
Turn the switch on
Put the plug in an earthed socket
Use a 230 V feed
Turn the switch on
Contact FireSales
Put the plug in an earthed socket
Use a 230 V feed
Turn the switch on
Remove the plug from the socket.
Make sure the smoke unit has cooled off
- Wipe away the liquid with a dry cloth
- Remove the liquid with the syringe
- Let the liquid evaporate
Put the plug in the socket and turn the switch
on.
Remove the plug from the socket
Fill the smoke unit with liquid (max.0,8 ml)
Put the plug in the socket and turn the switch
on.
Contact FireSales
Turn on/off switch off immediately
Remove plug from socket
Make sure the smoke unit is cooled off and
then remove the remaining liquid from the
unit
1.
User Manual Smoky Multi Socket
15
2.
3.