InfraWave IQPC Bedienungsanweisung Seite 4

Operating instructions (Stand-alone)
EN
General
If the infrared cabin is connected to the mains the following message appears on the display.
Every time a key is pressed a small beep will sound. When a function is not available or
when a value can no further be adjusted the beep will sound " less friendly".
The cabin light and the floor heating can always be switched on or off.
Infrared session
An infrared session is started by pressing the Timer key.
The following message appears on display:
The infrared heaters, the floor heating and the cabin light are switched on immediately.
When the session has expired the unit automatically returns to stand by. The session can be
ended manually by pressing the Timer key for 2 seconds.
The arrows (> or <) in the display message indicate which value can be changed by using
the up and down keys. In this case the session time. This is the default view during the session.
During a session the display shows the remaining time. The last minute is shown in seconds.
Ш When the Front Zone key is pressed, the signs shift to the Front Zone settings. The power
of the Front Zone can be switched now with the up and down keys.
Ш When the Back Zone key is pressed, the signs shift to the Back Zone settings. The power of
the Back Zone can be switched now with the up and down keys.
Ш When the Leg Zone key is pressed, the red color of LED sings that Leg Zone are turn ON,
Ш When the Floor heating key is pressed, the red color of LED sings that Floor heating
are turn ON,
Cabin light
During an infrared session and in stand-by mode the cabin light can be switched on and off
with the Light key.
At the end of an infrared session the cabin light is automatically switched on and stays on
two minutes have been expired or the light is manually switched off.
STANDBY
> Time: 23 min <
F :70% R :70%
– Turn ON of the Leg Zone
– Turn ON of the
Floor heating
– Turn OFF of Leg Zone
– Turn OFF of the
Floor heating