Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating instructions IR control panel
Using the panel, infrared elements can be split into 4 zones: front heaters dimmable, back
heaters dimmable, feet ON/OFF and legs ON/OFF.
During an infrared session the user can adjust the power (intensity) per zone individually of
front and back zone.
General safety warning
The unit is considered as the assembly of control panel, power controller, infrared elements
cabin light, temperature sensor and all the necessary cables.
The unit has no real on/off switch! The unit can be switched into standby mode, which means the
infrared elements are switched off. However, dangerous voltages can still be present.
The mains voltage can really be switched off by:
-
Pulling the mains plug out off the socket.
-
Installing an external bipolar switch in the mains cord.
The power controller has no parts or setting which are of interest for the user.
Only skilled personnel may open the power controller after the mains has been switched off.
Replacing or servicing the heater elements or cabin light may only be done after the mains
has been switched off.
Control panel keys:
Timer
This key starts or stops the infrared session. During a session this key is used to select the
time adjustment
Front zone
Adjustment of the power of Front Zone can be done with the Up and Down keys.
Back Zone
Adjustment of the power of Back zone can be done with the Up and Down keys.
Leg Zone
Switch the leg heater ON and OFF.
key.
Up and Down
Use the Up and down keys to adjust the power and the session time.
Floor Heating
Switch the Floor heating ON and OFF.
the key.
Cabin light
Switches the cabin light ON and OFF.
The state of this output is lighted by the LED next to the
The state of this output is lighted by the LED next to
EN
Werbung
