Installation - Nuvo Player Portfolio Bedienungsanleitung

This instruction sheet covers the installation of the Nuvo
EN
audio from video sources, such as a TV, or combines with the Player Portfolio system to access a variety of streaming services and networked audio
content. Leave the Sound Bar free-standing by using the supplied feet, or mount it easily on a wall using the included wall-mount bracket. This
powerful 2.1 system provides excellent sound quality and includes an eight-inch wireless Subwoofer to complete the P500 audio experience.

INSTALLATION

The P500 is designed to connect directly to the network LAN or run using Wi-Fi. By using the USB port, the USB storage drive shares music content with
the Nuvo Player Portfolio system. Each zone represents an independent input. The P500 RCA stereo input accepts any analog line-level audio signal. The
TOSLINK input accepts a standard TOSLINK cable. These inputs are local to the Sound Bar and are not shared with other Player Portfolio system zones.
The Sound Bar supports the Subwoofer connection using a Sync button to connect the Subwoofer to the Sound Bar wirelessly. An LED light illuminates when
a connection is established.
Note:
USB drives must meet USB 2.0 requirements. Some USB drives may not be supported natively by the USB port. A micro-USB drive is recommended
for use with the P500.
STEP 1: Determine if the Sound Bar will be free-standing or mounted to the wall.
STEP 2: Perform the Sound Bar installation.
Free-standing Sound Bar installation: Attach the two rubber feet to the bottom of the Sound Bar.
Wall-mount Sound Bar installation: (Fig. 5)
• Hold the bracket up to the wall at the mounting location, making sure the bracket is level and located in an area where it can be attached to the wall studs.
• Use the bracket as a template to mark the four placement holes for the bracket fasteners.
• Use the four fasteners (provided) to secure the bracket to the wall. The fasteners provided are for a drywall surface.
Note: Use the appropriate fasteners or anchors for the wall surface. If mounting to the wall studs is not possible, use drywall anchors to secure the bracket.
STEP 3: Plug the provided 2 m Ethernet cable into the Ethernet port on the back of the Sound Bar. An Ethernet cable MUST be used for the initial setup of
the P500. During setup, the option is available to use the Sound Bar with either a 2.4 GHz or 5 GHz Wi-Fi network.
Note: After setup, to switch from 2.4 GHz to 5 GHz press and hold the mute button for five seconds.
STEP 4: Determine if you are using RCA cables or the TOSLINK cable for your audio.
• RCA Cables: Plug the RCA cables into the RCA jacks (Analog Input). The red RCA cable plugs into the red jack on the back of the Sound Bar. The white
RCA cable plugs into the white jack on the back of the Sound Bar.
• TOSLINK cable: Plug one end of the TOSLINK cable into the optical input port on the back of the Sound Bar.
Note: During setup, choose the input on the P500 for the TV connection. Only one input is active at any given time without changing the P500 zone settings.
STEP 5: If a micro-USB drive is being used with the Sound Bar, insert it at this time.
Note: Refer to the Nuvo Player Portfolio Audio System Product Manual to connect the Sound Bar to the Player Portfolio System and access streaming
®
services and/or networked audio content.
Player Portfolio Sound Bar and Subwoofer (NV-P500-XX). This versatile P500 system plays
®
Fig. 5 / Fig. 5 / Abb. 5 / Fig. 5 / Fig. 5 / Fig. 5
7