Additional Safety Information; Operation Conditions - Acer C200 Bedienungsanleitung

• OSD function list
(By Icon)
Display Mode: Choose your preferred mode from Bright, Standard or Eco.
Brightness: Adjust the brightness of the image.
Display
Contrast: Adjust the contrast of the image.
Projection Mode: Choose Front or Rear.
Aspect Ratio: Choose your desired aspect ratio.
Keystone Adjust image distortion caused by tilting projection.
Volume Adjust the headphone volume.
Information Display the projector information for this projector.
Language Select your preferred menu language.
Setting Reset: Choose "Yes" to return the parameters on all menus to the factory default settings.
Functions vary depending on model definition.
Note 1:
Note 2: Does not guarantee the USB speaker sound quality.
Information for your safety and comfort
Read these instructions carefully. Keep this
document for future reference.
Follow all warnings and instructions marked on
the product.
Using electrical power
This product should be operated from the type
of power indicated on the marking label. If you
are not sure of the type of power available,
consult your dealer or local power company.
Product servicing
Do not attempt to service this product
yourself, as opening or removing covers may
expose you to dangerous voltage points or
other risks. Refer all servicing to qualified
service personnel.

Additional safety information

• Do not look into the projector's lens when the
light is on. The bright may hurt your eyes.
• Do not place the product in following
environments:
■ Locations where excessive humidity, dust, or
cigarette smoke may contaminate optical
components, shortening the life span and
darkening the image.
■ Locations with an ambient temperature
above 40 ºC/104 ºF.
• Unplug immediately if there is something
wrong with your projector. Do not operate if
smoke, strange noise or odor comes out of
your projector. It might cause fire or electric
shock. In this case, unplug immediately and
contact your dealer.
• Do not face the projector lens to the sun. It can
lead to fire.
• Do not look into the air outlet grille when
projector is operating. It may hurt your eyes.
Disposal instructions
Do not throw this electronic device into the
trash when discarding. To minimize pollution
and ensure utmost protection of the global
environment, please recycle. For
more information on the Waste
from Electrical and Electronics
Equipment (WEEE) regulations,
visit http://www.acer-group.
com/public/Sustainability/
sustainability01.htm
Use projector in a sideway or ceiling mode
is not supported.
(By selection)
Regulations and safety notices
FCC notice
This device has been tested and found to comply with the limits for
a Class B digital device pursuant to Part 15 of the FCC rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This device generates, uses,
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause harmful interference
to radio or television reception, which can be determined by turning
the device off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the device and receiver.
• Connect the device into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/television technician for
help.
Notice: Shielded cables
All connections to other computing devices must be made using
shielded cables to maintain compliance with FCC regulations.
Notice: Peripheral devices
Only peripherals (input/output devices, terminals, printers, etc.)
certified to comply with the Class B limits may be attached to this
equipment. Operation with non-certified peripherals is likely to result
in interference to radio and TV reception.
Caution
Changes or modifications not expressly approved by the manufacturer
could void the user's authority, which is granted by the Federal
Communications Commission, to operate this device.

Operation conditions

This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Notice: Canadian users
This Class B digital apparatus complies with Canadian ICES-003.
Remarque à l'intention des utilisateurs canadiens
Cet appareil numérique de la classe B est conforme a la norme NMB-
003 du Canada.
CE declaration of conformity
We hereby declare above product is in compliance with the essential
requirements and other relevant provisions of EMC Directive 2014/30/
EU, Low Voltage Directive 2014/35/EU and RoHS Directive 2011/65/EU
and Directive 2009/125/EC with regard to establishing a framework for
the setting of ecodesign requirements for energy-related product.
English