Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User Manual
Once open you can find the program sitting in the system tray. You may need to click the caret (up arrow
icon) to show all of the running programs then right click on the Thunderbolt icon it and select Settings:
You should now see the settings window. Click on Details to find out all of the Thunderbolt software and
controller information. Unfortunately if a Thunderbolt device has not yet been connected to the system,
the information about the NVM firmware may not be available within the utility.
Installation:
After connecting the Thunderbolt 3 Notebook Docking Station to your computer, using the supplied
Thunderbolt 3 cable, any required drivers will be automatically downloaded from the internet.
Connecting Devices to the Docking Station:
Monitors: Connect a standard HDMI A Male/Male cable (not included) to the HDMI output of the
Docking Station and to the input port of your HDMI display. If you are using 4K 60Hz graphics, it is
recommended to keep the cable distance to 2m maximum. Use a Thunderbolt 3 (USB Type C) port
to connect another monitor. Depending on the display you want to connect, a USB Type C to Video
Adapter with DisplayPort Alternate mode support might be necessary. Two separate displays will
be detected and can be configured in Display Settings as usual.
Ethernet: Use a standard RJ45 Ethernet cable to connect the docking station to your network
USB: Up to five USB devices can be connected to the Docking Station using a USB Type A cable,
with the USB Type A port on the front left supporting Battery Charging 1.2 standard for faster
charging of mobile devices
Audio: A 4 pole Headset (including Mic) or Speakers can be attached to this port to provide
additional audio input/output.
English
Werbung
