FireAngel RLYM-1 Benutzerhandbuch Seite 6

Interconnect (I) - If desired, join the Interconnect wire
from the alarm network (RLYM-1 only,
see 'Hardwire Interconnect' below).
Use the Earth Terminal to safely terminate any copper
Earth or green / yellow cable.
Note: Wiring must be installed in compliance with local
AC Mains 230V
DC Power in 12V
(WRLYM-1 Only)
Trigger input 12-24V
External input
Please note: The battery back-up switch (5) must be switched to the "on" position prior to finalising the installation of the
relay unit and fitting the cover.
regulations and by qualified/competent personnel.
Disconnection Device (for permanently connected
equipment)
A readily accessible disconnect device (such as a separate
fused spur or MCB) can be incorporated externally to the
equipment to disconnect the device from the mains power.
LED
LRN
TST
Learn Button
Test Button
(WRLYM-1 Only)
6
Screw holes
DIP Switches
WARNING - Ensure to isolate the power
prior to operation of the dip switches.
Relay A
YT2
Trunking
Relay B